KL-15e KIRBY LESTER #16 COUNTS TABS, CAPS, PILLS, Little Used - XTRA FINE COND.

Description

NOTE. . .YEAGERENO2
; is not affiliated with The Kirby Lester Corp, a division of Capsa Solutions; is not an a
uthorized repair dealer; and cannot offer a Kirby Lester Corp.-supported warranty on any device, service or parts.
World Wide Shipping? Reduced Prices.
We will find the best combination of price and shipping cost for you
See below.
THE KIRBY LESTER PILL COUNTING Machine
MODEL KL-15e . . .
The Kirby Lester
Model
KL-15e, is regarded as "THE GOLD STANDARD"
and is the most used worldwide. It is capable of operating at either 110 volts (in The U.S.) and at 220v, in other countries with just the replacement of the cord to fit the countries electrical plug.
The machine is currently set up for 110 V. for use in the U.S.
This machine had a previous owner, but it was well taken care of, and in Xtra Fine condition. Notice the Little Wear on the zero button, an indication of use. (Please see pictures) . . .
PLEASE NOTE: All parts are stored and repairs are done in a SMOKE FREE Shop.
The NEW drop chute is a reinforced 1 piece Funnel and has no cracks or chips and the tray is also in Xtra Fine Condition with a clear Silver Strip on the bottom, front that is in pristine Condition.
This machine received a NEW Replacement Power Supply, and few new parts inside during rebuilding. Please Notice the condition of the face plate including the ZERO BUTTON. (Please See pictures attached that apply to this machine)
OTHER KIRBY MODELS AVAILABLE . . . SEE LIST IN PICTURES.
Kirby Lester Repairs,  We'll help you or do it for you.
Questions?. . Please see the last page of pictures.
This is an Xtra FINE example of a KL-15e manufactured in the later years. . . The Serial Number is stamped on the Kirby Lester plaque on the side of the machine. (Some Earlier models had the serial number  on a plaque on the back.
It  has been
Tested . . . All the Electronics are working and it exhibits the full accuracy of which all Kirbys are capable. . .
This Kirby Lester machine is most accurate when kept clean.
And, this machine is very clean . . (Please See Pictures Below)
This Kirby machine is NOT sold AS IS. . .
They are obtained from reliable sources in very good condition. . Then, each one is tested, and any parts that fail are replaced.
Then, it is retested, and many parts are replaced just because they are worn or weak, and may fail in the future.
After it is cleaned, fully refurbished, and detailed, to look as close to new as possible . . . Then, we test it, once again, for accuracy the 3rd time, and, it must pass, before we put it in our inventory on:
Ebay. . . See Seller: Yeagereno2
Once purchased, we retest your Kirby, for the 4th time, just before carefully packing
***
it for shipment, so that we can,
Guarantee it will
arrive
in perfect working order,
ready to give your operation, many years of productive service.
We also offer a fast inexpensive repair service for KL-15e's and other older Kirbys, with special attention to our preferred customers.
With this reconditioned KL-15e
You Get:
30 Day Warranty
Preferred Customer service and pricing
KL-15e Owners Info
T
roubleshooter's Guide to Diagnose & Repair
Last Revised June 2019
Pill contact parts are precision crafted from high impact sturdy plastic material . . . .
Metal cabinet is Powder Coated light Grey,
and the precision electronic counting boards are protected inside. .
These machines were built to give the greatest accuracy possible, (even better than hand counting on a tray), day in and day out, hour after hour of continuous use, for years and years, and we have many parts, if needed, to keep it going for many more years.  . .
These precision counting machines, and replacement parts, are for use in a licensed Pharmacy or Vitamin Filling Operation and can only be sold for such.
Proof of legitimate ligitimate use is required.
"The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping the item."
I am a Licensed Pharmacist and authorized to own this machine. I will comply with any and all laws applicable to this machine . . . My Name and Nevada Pharmacist License number are available upon request.
Questions? Please Read each Page of the pictures with this offering or the Troubleshooting guide listed as item #382733217954 elsewhere on Ebay, and contact us for an offer thru Ebay.
If This Information is Ordered, It will come to you by Email. Availability and prices of parts questions answered also. This information is Priced at .99. . But if you make me an Offer of just . . . I will accept it.  . . . . Price fully refundable with first order.
My Wife and I have used KIRBY LESTER counting machines in the practice of Pharmacy for over 46 years starting with our first KL-7 in our Pharmacy in 1975, Then, in a mail-order setting, for 11 years, I kept many KL-8s, KL-8 plus, KL-X and KL-15’s, operational, replacing parts, repairing electronic controller boards and circuit boards, etc. . . Jack Yeager R.Ph. retired
Until they were replaced by newer models and no longer available,
KIRBY LESTER Listed the KL-7 at a Retail of
5
in1975
The KL-8 was
95
and the KL-8 plus was
95
in 1985
.
The KL-X retailed at
95 in
1995.
If these were manufactured and sold today, they would cost much more to make.
The KL-X, in todays dollars, would have to retail for at least
95
The KL-15e was available NEW at over
00
PLEASE SEE THE PICTURES BELOW OF THE
ACTUAL KIRBY LESTER YOU WILL RECEIVE.
United States Priority Express Mail internationally has recently been reduced in price. Delivery Time is just 3-5 business days to your countries Customs Clearance. Ebay has also reduced their Shipping prices and delivery times.
Contact us about World Wide Shipping and we will find the best combination of price and shipping cost for you.
***
Special packaging for shipping.
Once you receive your Kirby, get it unpacked and established in it?s chosen position in your facility, you can depend on it to give you many years of productive service. .
But,
Your Kirby is at risk
during transit
, due to the rough handling or dropping of the packages by Shippers. The longer the distance a package must travel, the more chance there is of damage. In the past, we have had a problem with damage to about 1 out of 15 machines shipped in the
U.S.
and
Canada
. To effectively keep this damage, in transit, at a minimum, we have just invested in
special cushioning foam inside a fitted box
to protect your fragile Kirby machine.
This packing method was first used on the early KL-8s that were shipped from the
U.K.
to the
U.S.
The Kirby machine was surrounded by 2 inch rubber foam in a precisely sized box.
We are constantly trying different packing and cushioning methods to allow a Kirby Machine to withstand being dropped or thrown. The 2 inch foam surrounding the machine has been found to be the best first step. In addition, we wrap each Kirby in a ?Cocoon? of bubble wrap and stretch wrap. And, then use convoluted foam to fill in any spaces. We believe this
new cushioning method will fully protect our Kirbys
in the best manner possible.
Because of our trust in our new special packing method over long distances, we will be
starting to offer world-wide shipping
that was not available to customers in the past. Please contact us for the best shipping price to your location.
And, if your Kirby should sustain any damage in transit, despite our best efforts to keep this from happening, we will not leave you stranded. Since we
Guarantee your Kirby will be in perfect working order
, we?ll do what ever it takes to get a damaged Kirby in perfect running order or replaced, in the shortest amount of time.
Please
save the fitted box and the foam
, to use for storage, moving, or if your Kirby ever needs to be shipped.
*Exception, Clear capsules are not counted accurately because light beam passes through capsule. . .
WE will have replacement parts (New and Used) for these precision KL-15e machines for years to come. Please contact us for prices and availability.
We also offer a reasonable repair service, for this model and other KIRBYS.
We buy complete machines or parts, working or not.
SMOKE FREE SHOP